Hjemme teori skrev:Jeg har renset brænder jer i weekenden og fik så bedre syn for hvordan eltænderen virker. Fyret var lang tid om at starte bagefter, hvilket så var fordi gummiproppen ikke "holdt fast" i ledningerne til tænderen og den derfor var gledet lidt baglæns.
Når så jeg kigger ind i brænderen (gennem hullet til gummiproppen) kunne jeg se at den blæser luft forbi el-tænderen og direkte ud på pillerne.
Men det smarte her er at der er hul i den keramiske tænder og den luft der løber igennem må blive "meget" varm, men i en lille mængde (lille hul).
Hvis man nu kunne lave noget så den blev placeret lige midt i udblæsningen og blev siddene, tror jeg tændingstiden kunne blive endnu hurtigere. Tror også det er en af grundene til at vores tændtider variere lidt. Nogle tændere sidder mere rigtigt end andre.
Så nu er jeg gået i tænkeboks med hvordan det kunne laves uden at det kan falde ud og ned i blæseren (min tænder peger lidt for lavt).
Statestikken for min tænder er nu
stk 21
tid 1:16:30
Gennemsnit 3:39
Ja den skal skubbes helt frem, så den ligger helt op af det lille hul, og dermed er synlig. Hvis du har problemer med, at den ikke bliver liggende, men glider tilbage, så sæt en strip om ledningen på indersiden af gummiproppen. Man skal nørkle lidt med tænderen og løfte lidt op i ledningen for at få den helt frem. Det er muligvis kraven, der skal op over en kant inde i hulrummet.
Jeg bruger 70 gr. piller til optændingen.
Indtil videre har der ikke været nogen fejloptændinger, og jeg tror heller ikke der kommer nogen.
Venlig hilsen