Indlæg
af Bigfoot »
som andre har skrevet, vinkelsliber, vinkelret på gevindet, og så lige en pudsning rundt på gevindet.
Du skal bare huske, at den skive du skal bruge, skal være til rustfri, da de normale indeholder jernspåner, og bruger du sådan en på rustfri, så ruster det efter en kort rid.
Du må heller ikke bruge den i andet end rustfri stål, da det ødelægger legeringen, når man tilføjer jernpartikler under slibning.
"omdrejningstal, kølevandstemperatur, og turbotryk, er alt sammen totalt ligegyldige parametre, som man egentlig ikke skal gå så højt op i."
citat Bigfoot, herning pullingarena.